Are the proposed structures (designed and optimized) less
safe than conventional ones?
Optimization operations, although can reduce costs considerably, do not decrease the
Structural safety. In fact, with this method, surplus materials are eliminated. In most cases, the use
of these techniques not only does not undermine the performance of the structure, but also changes the
structural load distribution , which will reduce serious damages.
At the end of optimization process user get CSI (SAP2000 or ETABS) model of the structure which can tabulate
any violation of design criteria.
Can I customize the constraints of the design?
For each section, defining of related common constraints is prepared and the user can define its
project constraints through some forms easily. Nevertheless, customizing of uncommon special constraints
is not prepared and you can contact us in proper to developmental your ideal constraints.
How much cost difference is between typical and optimal
We use techniques that usually optimize your structure up to 20%. However, we cannot propose
a general value for all types of structures. Because this topic is heavily influenced by the type of
structure and first design. For this reason, in some sectors, the payment amount is calculated in terms
of the optimized amount of the structure.
Which constraints are considered for reinforced concrete
Strength , serviceability and ductility criteria derive from the design provisions of
ACI 318-08 . Also, geometric constraints are considered that contains dimensional limits for beams and
columns, minimum and maximum area of longitudinal reinforcements and some constructional criteria for
How do you calculate the weight of reinforcements in
Flexural, shear and torsional reinforcement is considered based on a program analysis results
for beams and defined section for columns..It may increase after detail design related to rebar anchor,
development length and cover system.
How do you compute the story drift?
According to the ASCE7-16,the story drifts are computed as the difference of the lateral load
deflections at the center of mass between the two story (for regular structures). Although the analytical period
for each structure can be considered for calculating lateral load, but this feature is not considered
and lateral load is considered fixed.For SAP2000 model the points (center of mass) must be assigned in a
group (Group-Disp) and drift is controlled only for these points.